DEEN
Thermometer

Current research projects

Image Panel with indirect evaporative cooling via membrane
Image Mass Spectrometer
Image Solar Cooling
Image Testing of mobile leak detectors according to DIN EN 14624
Image Humidifier System for High-Purity Gases
Image Testzentrum PLWP at ILK Dresden
Image Cryogenic liquid piston pumps for cold liquefied gases like LIN, LOX, LHe, LH2, LNG, LAr
Image Laseroptical measurement
Image Innovative Parahydrogen Generator Based on Magnets
Image Software for technical building equipment
Image Innovative cryogenic cooling system for the recondensation / liquefaction of technical gases up to 77 K
Image Test rigs for refrigeration and heat pump technology
Image Lifetime prediction of hermetic compressor systems
Image Development of a Cryogenic Magnetic Air Separation Unit
Image Tribological investigations of oil-refrigerant-material-systems
Image Low Temperature Measuring Service

You are here:   /  Home


Certifiable connection types in cryogenics

Dr. Andreas Kade

+49-351-4081-5117

Detachable and permanent connections, adhesive bond / form closure / force closure

The applications of cryogenic and vacuum technology impose special requirements on connection technologies. To determine the appropriate connections the application parameters such as temperature, vacuum and pressure, leak rate, materials, surface properties, radiation resistance, magnetic permeability etc. should be considered.

Connection technologies even if not being part of a standardized process more often have to be subject of a certification or qualification due to increasing quality requirements, e.g. pressure equipment directive 2014/68/EU. Therefore adequate designing and testing is necessary.

Alternative to electroplating process: cold gas sprayed copper layer (> 2 mm) with subsequent thread insertion
Alternative to electroplating process: cold gas sprayed copper layer (> 2 mm) with subsequent thread insertion

Innovations

The intended innovations relate to complete cryogenic systems considering the process chain from room temperature to low temperature range regarding the respectively required specifications. 

  • Development of application-related connection technologies with defined requirements and derived mechanical limit values 
  • Examination of existing connection technologies regarding applicability and further development towards secure and functional technologies
  • Evaluation and definition of application limits to aim for a feasible certification and the subsequent conformity with European guidelines

Project objectives

  • Application-related examination of various connection technologies
  • Further development and adaptation of existing connections to the requirements of cryogenic and vacuum technology
  • Examination on composite materials 
  • Examination on component geometries and their influence on the connection
  • Determination of process parameters (e.g. TIG welding, brazing,...) 
  • Determination of test limit values, especially for test specimens deviating from standards
  • Calculation according to common standards, simulation (FEM, ...) and testing
  • Realization and certification of selected connection technologies
Example of an examined connection between two materials (steel and PET) using a cutting edge at -90 ° C
Example of an examined connection between two materials (steel and PET) using a cutting edge at -90 ° C
show full article

Your Request

Data Privacy Settings

Cookies are used on our website. Some of them are mandatory, while others enable us to improve your user experience on our website.

Get more info about used cookies