Current research projects

Image Heat2Power
Image Non- invasive flow measurements
Image Reduction of primary noise sources of fans
Image Innovative small helium liquefier
Image Computational fluid dynamics CFD
Image Test procedures for electrical components
Image Filter Tests
Image High Capacity Pulse Tube Cooler
Image Verification of storage suitability of cryo tubes
Image 3D - Air flow sensor
Image Influenced melting point of water by magnetic field
Image Test rigs for refrigeration and heat pump technology
Image Cryostats, Non-Metallic and Metallic
Image Cold meter
Image In-situ investigation concerning the swelling behaviour of polymer materials under elevated pressures and temperatures
Image Thermal engines

You are here:  Home /  Measurements and Tests


Cold meter

Industry

R. Paatzsch

+49-351-4081-5220

The fast way to refrigerating capacity

The ILK Dresden offers you special cold meters to determine the exact cooling capacity of your refrigeration system. These consist of a mass flow sensor, pressure sensors, temperature sensors and a suitable measured value acquisition. The associated software stores and analyses the measured values. The evaluation provides clear diagrams and key figures. Of course, the systems are calibrated before commissioning and can also be recalibrated.

Specification

  • refrigeration capacity range: ~ 0,5 kW … 300 kW (other ranges on request)
  • all common refrigerants
  • mass flow measurement is operating with the principle of a Coriolis flow meter
  • measurement of temperature and pressure in the refrigeration cycle
  • calculation of the refrigeration capacity from material properties using Reflib of the ILKs
  • comfortable evaluation and calculation software
  • monitoring of different parameters
  • hardware monitoring of measuring channels and network connection
  • error analysis

Your Request

Further Projects - Measurements and Tests

Image

Mass Spectrometer

Determining the composition of gas mixtures in the high or ultra-high vacuum range

Image

Tensile and compression testing

Determination of yield strength, tensile strength and elongation at break

Image

Investigation of material-dependent parameters

Investigation of the permeation behavior

Image

Low temperature – test facilities

thermal cycling tests at very low temperatures